Are You Ready For The Next One?

Weld Stud Design

FEMA 320 Door

Jam Mount Design FEMA 320 Door with Cylinder lock access

Pictured:

FEMA 320 Angle Iron Frame with

added cylinder lock

Angle Iron Frame design FEMA 320 Door with Upgrades of: Panic Pin, Cylinder Lock, Peephole and 14 gauge backer plate. Right hand picture is the front of the door. Top left is the back side of the door with backer plate. Bottom left picture is of panic pin. 

Steel Storm Shelters LLC 

FEMA 320/ICC 500

Storm Shelter Doors

* Custom Sizes starting at $2500.00

* Texas Tech Texas Tested and Approved

* Structural Engineer stamped for meeting all FEMA 320 guidelines.

* Complies with ICC 500 Standards

* 6 Point door attachment 

* Anti jamming lock and handle

*Shipping anywhere in the United States. Additional fees apply.

The Tornado Tamer SafeDoor is Texas Tech tested and 3rd party certified by a professional engineer for use in FEMA 320 settings upon concrete pour or concrete block shelters. FEMA 320 designates typical residential use. This is the same door style that is used upon our SafeRoom storm shelters.

The door was tested as a complete unit; jam, door, and locking system. It does not remove from its frame. Our door is welded to hinges which are then welded to the door frame. 

Steel Storm Shelters LLC FEMA 320 Storm Shelter doors are made of 1/4 plate steel on a steel tubing frame. The jam is made of ts 2" X 4". This assembly is set into a 4" angle frame. It is made to set into the opening and upon the face of a concrete shelter within your home or a concrete block type shelter. It does not have an interior trim. This trim can be achieved with wood after the door is mounted and attached.

The door opens and locks with a single turn that sets 3 steel cams; one in the top jam, one at the latch side, and one into the bottom jam plate. The door is painted using a Farrel Calhoun product in color Moth Wing.

Anchorage is achieved with 1/2"X4" minimum embedment wedge anchors set into solid concrete wall or 1/2"X4" minimum embedment sleeve anchors if the wall is block with concrete to backfill. Anchorage is made thru the angle iron frame face and into the wall behind. *We do not provide the anchors for the door system. These are difficult to ship with the door and easy to attain at a local hardware store.

The SafeDoor is available with a weld stud design if the face attachment is not preferred method to embed or attach the door to the shelter. The door is built with weld studs extending from the 2X4 tube steel that allow embedment of the studs into the pour of your shelter or to extend into the concrete block wall in order to be encompassed with the concrete backfill pour.

If you need the door made for the opening you have already formed, we can accommodate this request. We can email you a questionnaire . Use it as a guide to provide some basic measurements. We will then build the door to work with your existing opening.

Large orders welcome and discounts considered for multiple doors ordered. A past order of 28 doors went to Peoria, IL for a project. 5 went to Alcorn County, MS for Community Shelter projects thru out the county.

We are the manufacturer and sell to the public as well as contractors and dealers.

You can pick up a door at our shop in Henderson, TN or for an additional charge have it shipped to your desired location.

Upgrades Available:

14 gauge backer plate (cosmetic purposes only)
Cylinder lock (to secure valuables with a keyed lock)
Peep hole (for viewing outside)
Panic Pin (for securing door lock from intruders)
Insulation (for noise, no claim for R factor)

Shipping

~Locally Owned & Operated

~Meets or exceeds FEMA 320 guidelines

~Texas Tech Tested/Approved